Documentation
The Chas E. Phipps Tech / SDS Documents system is a search service to product information for the Concrete, Finishes, Masonry and Thermal and Moisture Protection Divisions. All documents are in pdf format and have been compiled from manufacturer websites.
TERMS AND DISCLAIMER: ANY MATERIAL ACCESSED, DOWNLOADED OR OTHERWISE OBTAINED THROUGH THIS SYSTEM IS DONE SO AT THE USER’S DISCRETION AND SOLE RISK. THE CHAS E. PHIPPS COMPANY DOES NOT GUARANTEE THE COMPLETENESS, ACCURACY, QUALITY OR CONTENT OF ANY OF THE DOCUMENTS ACCESSED, DOWNLOADED OR OTHERWISE OBTAINED THROUGH THE SYSTEM, WHICH DOCUMENTS MAY BE AMENDED, CORRECTED OR SUPERSEDED FROM TIME-TO-TIME BY THE MANUFACTURER. USERS ARE CAUTIONED TO ALWAYS CONSULT THE ORIGINAL MANUFACTURER DOCUMENTS. USERS AGREE THAT UNDER NO CIRCUMSTANCE SHALL THE CHAS E. PHIPPS COMPANY BE LIABLE IN ANY WAY FOR (1) THE CONTENT OF ANY DOCUMENTS, INCLUDING BUT NOT LIMITED TO ANY ERRORS, OMISSIONS OR CHANGES IN ANY DOCUMENTS, OR (2) ANY LOSS OR DAMAGE OF ANY KIND (INCLUDING BUT NOT LIMITED TO ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, CONSEQUENTIAL OR EXEMPLARY DAMAGES, ATTORNEYS’ FEES AND/OR COSTS) ARISING FROM, RELATING TO OR OTHERWISE INCURRED AS A RESULT OF THE USER’S USE OR VIEWING OF SAID DOCUMENTS ACCESSED, DOWNLOADED OR OTHERWISE OBTAINED THROUGH THIS SYSTEM.
Product Description
Two-component epoxy preparation material for the installation of Ardex underlayments and toppings. Primer for concrete and non-porous substrates such as terrazzo and epoxy coatings. Required primer for decorative applications of Ardex self-leveling toppings. Can be used as crack filling material. Can be used to provide secondary top-down waterproofing Solvent-free, low viscosity, 100% solids epoxy resin. Receives sand broadcast Use for interior and exterior substrates.
Mixing Ratio: Add entire pre-measured contents of Part B (Hardener) into Part A (Resin)
Coverage: The required thickness for the Ardex MC Rapid is dependent on application; see below. Note that application rates are approximate and dependent on concrete surface profile, texture and porosity
Sand Broadcast required | Minimum Installation Thickness | Approximate application rate per mixed unit: | |
Underlayments up to 1/4" thick | No | 10 mils / 250 microns | 250-270 ft² |
Underlayments greater than 1/4" thick | Yes | 14 mils / 350 microns | 170-190 ft² |
Toppings | Yes | 14 mils / 350 microns | 170-190 ft² |
Fast-track primer (no moisture mitigation) | Yes | 10 mils / 250 microns | 250-270 ft² |
Direct installation of floor coverings (no underlayment) | Yes | 10 mils / 250 microns | 250-270 ft² |
Ardex ACMS | Yes | 14 mils / 350 microns | 170-190 ft² |